中文
ENGLISH
This is an automatic model
1 This is the main power switch, 2 the handbrake, 3 the instrument board, the joystick with high gear, neutral gear and low gear. This is the joystick for forward and backward. This is the running gear for high and low speed. This is the joystick to control the open and close of the et, as well as the raising up and down of the boom. If I pull the joystick forward, it’s going to bring the boom down, while pulling it back, it’s gonna to raise the boom up; If I go right hand to the left, if I go it will close the et; left hand to the right, it’s gonna open the et.
This is the brake pedal; this is the accelerator pedal;
Here are the operating steps
Step 1 . Key the power switch on.
Step 2. Check to see whether the joystick is in the neutral state, and then activating the vehicle.
Step 3. Raise the boom up and curl the et to have the boom hinge point 40cm to 50cm off the ground.
Step 4. Hold the steering wheel with your right hand and put the lever in the required gear with your left hand.
Step 5. Observe the situation around the vehicle, press the horn and release the hand brake.
Step 6. Step on the accelerator pedal gradually to make the loader start smoothly.
While starting, listen to the sound of the engine, if the rotate speed drops, continue to step the accelerator pedal to increase the engine speed to facilitate the starting.
